Thank you.
We are using it in WASPI mode (Non Exclusive) what should the buffer ideally be?
We are using it in WASPI mode (Non Exclusive) what should the buffer ideally be?
- Welcome to MultiMedia Soft forum.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Audio playback and audio management components / Audio Drop Out
May 02, 2017, 08:50:35 AM
Hello,
We seem to have an odd situation where we sometimes experience an audio drop out for around 100ms which causes the perception on air of a stutter or a skip. We have the main buffer set to 750ms which seems more than enough. Any higher and the buffer starts affecting volume automation.
We seem to have an odd situation where we sometimes experience an audio drop out for around 100ms which causes the perception on air of a stutter or a skip. We have the main buffer set to 750ms which seems more than enough. Any higher and the buffer starts affecting volume automation.
#3
Audio playback and audio management components / Re: Sound hikking/skipping using LoadInternetStream
May 02, 2017, 08:48:40 AM
Hello,
Just wondered if this was ever resolved. We have the same issue.
We load an internet stream and on occasion it stutters every roughly 5 seconds.
If we close the stream and re-load it then the stutter clears.
This doesn't happen every time.
We are playing an OPUS stream and target it using the OPUS encoder direct
Internet buffer set to 1000
Just wondered if this was ever resolved. We have the same issue.
We load an internet stream and on occasion it stutters every roughly 5 seconds.
If we close the stream and re-load it then the stutter clears.
This doesn't happen every time.
We are playing an OPUS stream and target it using the OPUS encoder direct
Internet buffer set to 1000
#4
Audio playback and audio management components / Re: Audio Hicup When Using Pitch
May 17, 2016, 04:24:53 PM
Audio files (not audio streams)
#5
Audio playback and audio management components / Re: Audio Hicup When Using Pitch
May 16, 2016, 01:35:03 PM
It's just using the setPitchFloat
#6
Audio playback and audio management components / Re: Audio Skipping & Clicking
April 29, 2016, 03:21:35 PM
We found that using ASIO instead of DS fixed this issue.
#7
Audio playback and audio management components / Audio Hicup When Using Pitch
April 29, 2016, 03:21:11 PM
Hello,
I'm getting an odd hiccup every so often when using a player with pitch enabled. I have the value set to 0.3 but every so often i get a little hiccup in the audio as if the pitch process has slowed or sped up slightly which results in the audio giving a little hiccup.
I'm getting an odd hiccup every so often when using a player with pitch enabled. I have the value set to 0.3 but every so often i get a little hiccup in the audio as if the pitch process has slowed or sped up slightly which results in the audio giving a little hiccup.
#8
Audio playback and audio management components / Re: Audio Skipping & Clicking
April 21, 2016, 10:14:50 AM
Hello and thank you for the quick reply!
No obvious CPU spikes. The soundcard in question is Virtual audio Cables.
Audio Engine 11.3.0.1 seems to be ok. Could anything in my code be perhaps causing this? We are using Direct Sound.
No obvious CPU spikes. The soundcard in question is Virtual audio Cables.
Audio Engine 11.3.0.1 seems to be ok. Could anything in my code be perhaps causing this? We are using Direct Sound.
#9
Audio playback and audio management components / Audio Skipping & Clicking
April 20, 2016, 11:19:56 PM
Hello,
I just wondered if anyone using Active DJ Studio (Audio Engine 11.3.0.3) has experienced intermittent popping, skipping or clicking in their audio application when playing audio. I've attached a sample piece of audio. In the first two songs you can hear clicking in the recording (all be it very faint!) and then on the third song the audio actually skips. This seems to have only happened since audio engine 11.3.0.2.
It can be reproduced on a number of different machines and operating systems so I know it's not a specific PC. I haven't changed any code in the audio side of things either.
On occasions the clicking gets worse the longer the application runs. If however I go into my application and change the audio device and then switch back the clicking stops for a little bit.
It's driving me crazy!
Audio Sample is here https://www.dropbox.com/s/w2wcm5204oy66zq/Skipping.mp3?dl=1
I just wondered if anyone using Active DJ Studio (Audio Engine 11.3.0.3) has experienced intermittent popping, skipping or clicking in their audio application when playing audio. I've attached a sample piece of audio. In the first two songs you can hear clicking in the recording (all be it very faint!) and then on the third song the audio actually skips. This seems to have only happened since audio engine 11.3.0.2.
It can be reproduced on a number of different machines and operating systems so I know it's not a specific PC. I haven't changed any code in the audio side of things either.
On occasions the clicking gets worse the longer the application runs. If however I go into my application and change the audio device and then switch back the clicking stops for a little bit.
It's driving me crazy!
Audio Sample is here https://www.dropbox.com/s/w2wcm5204oy66zq/Skipping.mp3?dl=1
Pages1